Force Sensors

Broad range of force sensors serving all industries

Our dynamic force sensor product range covers miniature size to high stiffness type serving industries such as Aerospace, Automotive, Medical, Laboratory Commercial and Industrial. The dynamic force sensors are used in wide range of application.


  • Miniature size
  • Low mass model available, around 4.5 grams
  • Integral cable
  • IEPE
    • High stiffness
    • High natural frequency
    • Axial connector
    • Radial connector
    • 10-32 mounting top and bottom
    • Up to 50,000 lbf compression range

Wide frequency range

Aerospace and Defence

  • Flight and flutter testing (airborne)
  • Health & Usage Monitoring Systems (HUMS)
  • Ground Vibration Testing (GVT)
  • Satellite testing
  • Change table to a drop list where there’s side panel for user to select the content that they wish to see

Landing gear assemblies

  • Rotorcraft and fixed wing aircraft monitoring
  • High g shock testing

Automotive Testing

  • Component durability
  • Modal analysis/body-in-white
  • Crash and airbag safety testing
  • Noise, Vibration and Harshness (NVH)
  • Squeak and rattle evaluation
  • Transmission testing
  • Ride quality and other
  • vehicle dynamics

General Laboratory Testing

  • Product response
  • Mechanical impact
  • Package design integrity
  • PC boards and assemblies
  • HALT/HASS

Environmental Stress Screening (ESS)

  • smallest and most lightweight package available
  • Applying quartz sensing element, operating in compression mode and packaged in a lightweight titanium housing
  • precision force measurement capabilities
  • of up to 50 lbf, with a 100 mV/g sensitivity and an unloaded 50 kHz natural frequency
  • 10-32 tapped holes, located at both the top and bottom of the sensor hosing, are designed to facilitate mounting of the sensor into threaded holes on the driving rods and test specimen
  • Units were designed to measure rapid or slowly changing dynamic forces in machinery and in other applications where a thru stud or bolt holds the sensor in place in a preloaded condition.
  • Measure vibratory compressive forces over a wide frequency range and unidirectional pulsing forces from punch and forming presses and other repetitive force applications as well as impact forces.
  • As IEPE sensors is with built-in electronics, eliminating the need for an external charge amplifier and converter.
  • Units utilize a 10-32 radial connector design, thru-hole mounting and are hermetically sealed for reliable operation in high-humidity and dirty environments.